March 31, 2014

AV8 8" home theatre speaker


 AV8 is a home theatre speaker based on a 1" compression driver, 8" waveguide and 8" midbass driver. Shown here on my measurement turntable where the dispersion performance is tested. The MDF enclosure is rubber lined for vibration damping and it's also sealed with fibreglass resin to resist moisture changes, hence providing a good substrate for the textured paint finish that will be applied. 

AV8 is a 93 dB speaker designed to reach THX reference levels with an ordinary AV receiver. It has an 8 ohm load, 70 Hz extension and a small box. Being an AV speaker, it's anticipated that it will be placed near the wall. This particular pair is designed for a client where it will be placed on a pro audio bracket.

The midwoofer has a clear coating which helps to damp cone breakup. When testing the raw driver with no filters in place, this is audible in comparison to lighter untreated cones. 


This is an alternative driver that was tested, without the treated cone. It has higher sensitivity in the upper midrange, but cone breakup is clearly audible. Although a cheaper driver, the savings are likely lost in a more expensive crossover.

 
Woofer baffle. Neo magnets are hidden in the baffle for grille attachment of woofers. These are machined manually, not via CNC, since they are machined from the rear of the baffle and this doesn't easily suit the CNC process, where all work is done from the top side. This is done with a drill press manually, then what remains is filled with bog. A straight cut bit is used, since a drill bit would not let the magnet get close enough to the surface without breaking through. 

The baffle above is for the surround (AV8S).

CNC panels laid out:


Rubber sheets line the box for vibration damping. 

Front baffle:

AV8S construction. Damping rubber and some of the lining is attached during assembly, as access is limited after.




Woofer baffle is double thickness.


Keyhole brackets allow the box to be installed to the wall. You can also see a recessed section around the speaker terminal cut out. This allows a speaker wall plate to be located here, so all cabling is hidden, and installation is simple, with no need to offset the speaker from the wall.


Top and back of the surround (AV8S). Dual ports fire up out of sight.


Sometimes you just can't have too many clamps!


The compression driver/waveguide for the surround is angled down 15 degrees. 


AV8


AV8S (surround) rear sitting upside down. Here I've used a neo driver to keep the weight down.



AV8 rear:




3 comments:

  1. Are you going to publish any measurements for the AV8? I would love to see some measurements for the AV8 and that waveguide.

    ReplyDelete
  2. I've just added a directivity sonogram as a new post. Of course, if you are thinking of using this waveguide, you will need to measure it with the compression driver you are using, as they don't all measure the same.

    ReplyDelete
  3. Thank you for posting the sonogram! :)
    I plan on using a different waveguide so I'll have to run my own measurements for sure.

    ReplyDelete

All comments are moderated.